Materials
3D printing in PETG
The usual choice for parts that really work: holders, housings and covers that take impact, moisture and oils.
Good for
- Holders, housings and covers
- Parts exposed to moisture or oils
- Spare parts without high temperature demands
Not good for
- Temperatures above about 70 °C
- Long exposure to sunlight: it fades over time
- Very fine detail: the surface is less clean than PLA
At a glance
- Behaviour
- Tough, with a little flexibility
- Density
- 1.27 g/cm³
- Heat deflection temperature (HDT)
- ~70 °C
An indicative value, from the material's datasheet. If your part works near this temperature, tell us.
Have a part to print?
Send us the file and we reply with a quote, during working hours.